Bathmate Hydromax X30 Male Enhancement Penis Enlargement Pump Clear
Recommended Exercise Regime.In order to obtain optimum benefit from the Hydropump and to avoid inappropriate use which may cause discomfort, you are strongly advised to follow the exercise regime as outlined below:
1. Ensure your pubic area is reasonably well trimmed. This will facilitate the vacuum seal against the pelvic seat.
2. A relaxation period of a few minutes in a warm shower or bath is required to allow the testicles to soften, allowing them to remain free from the sealing area thereby avoiding any discomfort.
3. Avoid over vigorous pumping as this will not give the best results, and may cause discomfort, speckling spots or bruising.
4. To benefit the most in erection hardness and optimal blood flow, it is best to remove the device every 2-3 minutes and allow the penis to retract. Massage the penis in the flaccid state, then re-apply the device and repeat the process. You should do this a maximum of 3 times in any 15 minute session.
How the Hydropump works
The Hydropump functions by creating a vacuum seal against the pubic area of the user, enclosing the flaccid penis. When the pump is pushed downwards against the body, the bellows compress and water is ejected from the end of the pump via the open valve. When released the bellows expand and the valve closes, creating a partial vacuum inside the pump. This causes the penis to expand and fill with blood, creating an erection. Re pumping increases the vacuum, and so increases the size of the erection.
The user controls the level of vacuum by depressing the valve inwards against the spring, opening the valve and allowing air or water back into the body of the pump, thereby partially or fully releasing the vacuum.
The black pip on the top of the valve is moved by pressing inwards and moving to the right or left, where it should “click” into position closing the valve. The closed position should only be used whilst filling the Hydropump with water in the shower. At all other times the black pip should be in the central (open) position. Failing to ensure that the black pip is in the central position will prevent the Hydropump from operating correctly.